"Chris B" <nom### [at] nomailcom> wrote:
> Yes, but in the modeller you need to decide which bit of a model is
> positioned at <0,0,0>.
> If you centre two differently shaped door handle models so that their
> geometric centres are at <0,0,0>, then you have to perform different
> translations to fit each of them to a door. >

 You lose me when you say "geometric centres are at <0,0,0>"

Who, What decides centres to be at <0,0,0>, when why how,

If I can figure out the answer to these, I will have rotation by the balls.

Grateful =)

Post a reply to this message